18
Configuring the OSD
Displaying the Dome Address
Each dome on your network is assigned a unique identifier (for example, CAM 001).
This is the dome address. You can show the dome address on the screen.
To show/hide the dome address:
• Select 2 Display Options
1 Camera Msg ON or OFF (default)
To change the location of the dome address on the screen:
1. Select 2 Display Options
6 Change Camera Name Loc.
2. Position the dome address on the screen by moving the controller joystick
up or down.
Displaying Sectors and Presets
After you have programmed sectors and presets (see Configuring Presets,
Tours, Privacy Zones, and Sectors on page 55), you can show the current sector
and/or preset on the screen.
To show/hide the sector name:
• Select 2 Display Options
2 Sectors ON or OFF (default)
Note If the dome has overlapping sectors displaying at the same time, the
two sector names alternate on the screen at 1.5 second intervals.
To change the location of the sector name on the screen:
1. Select 2 Display Options
7 Change Sector Name Loc.
2. Position the sector name on the screen by moving the controller joystick up
or down.
To show/hide the preset name:
• Select 2 Display Options
3 Preset Names ON or OFF (default)
To Next Page
Loading...
