Honeywell ACUIX - Setting E-Flip and Mirror Image; Setting the Vertical Phase Edge

ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Document 800-05662V1 Rev A 47
04/11
To enable/disable manual white balance:
• Select 5 Camera Options  4 White Balance  1 Manual White Balance 
ON
or OFF (default).
To set red gain and blue gain:
1. Enable manual white balance.
2. Select 5 Camera Options
 4 White Balance  2 Red Gain 0–511 or
3Blue Gain 0–511.
3. Select a value between 0 and 511 (default = 128).
Setting E-Flip and Mirror Image
E-Flip turns the image upside down. Mirror Image reverses the image
horizontally.
To enable/disable E-Flip:
• Select 5 Camera Options
 5 Video Options  2 E-Flip  ON or OFF
(default).
To enable/disable Mirror Image:
• Select 5 Camera Options
 5 Video Options  3 Mirror Image  ON or
OFF (default)
Setting the Vertical Phase Edge
Vertical Phase Edge, or line lock, lets you synchronize all analog cameras
connected to the same power line. This prevents the picture on the monitor from
rolling vertically when switching from one camera to another.
Line lock can also help an analog VCR to remain in sync when switching
between properly adjusted, line-locked cameras. Line lock is generally of no
benefit with digital (LCD or flat screen) monitors and DVRs.
Note You need an AC power supply to use this feature.