Honeywell ACUIX - Setting the Startup State Restore; Setting Auto Focus

ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Document 800-05662V1 Rev A 27
04/11
Setting the Startup State Restore
By default, the dome automatically "finds home" on startup. When this function
is enabled, the dome will find home on startup and then revert to the position it
was at prior to the last shutdown, as well as the function it was executing prior to
the last shutdown.
To enable/disable startup state restore:
1. Select 3 Control Options
 4 Set Pan and Tilt Options  7 Startup State
Restore
 ON (default) or OFF.
2. If ON is selected, the following message appears:
Extreme Caution: This will move the dome to previous shutdown
position on startup. Are you sure that you want to do this? Y/N
.
Select Y (yes) to continue, or select N (no) to cancel.
Setting Auto Focus
Auto focus causes the lens to remain in focus when using zoom and/or pan and
tilt functions. The following auto focus settings are available:
• Z: The camera focuses automatically when the zoom setting changes.
• PTZ: The camera focuses automatically when using PTZ functions.
• OFF: The focus is operated manually using the controller.
To set auto focus:
• Select 3 Control Options
 6 Auto Focus  Z (default), PTZ, or OFF.
To set preset and preset tour auto focus, see Setting Preset Auto Focus on page
56 and Setting Preset Tour Auto Focus on page 60.