Document 800-05662V1 Rev A xv
04/11
About This Document
This document provides detailed instructions for installing, configuring, and
operating the ACUIX™ High-Speed PTZ Dome. These instructions are intended
for system installers, administrators, and operators.
Overview of Contents
This document contains the following chapters and appendixes:
•
Chapter 1, Introduction
, introduces dome features, terminology, and the steps required
to set up and configure a complete ACUIX system.
•
Chapter 2, Installing the Scan Assembly
, describes how to install the scan assembly and
bubble.
•
Chapter 3, Preparing to Configure the Dome
, describes how to access and navigate the
on-screen display menus. It also lists special presets.
•
Chapter 4, Configuring the OSD
, describes how to set up the on-screen display.
•
Chapter 5, Configuring PTZ Control
, describes how to set up PTZ control.
•
Chapter 6, Configuring HDXA, HDXJ, and HDXF Camera Settings
, describes how to set
up the camera and picture quality settings for HDXA, HDXJ, and HDXF cameras.
•
Chapter 7, Configuring HDXG Camera Settings
, describes how to set up the camera and
picture quality settings for HDXG cameras.
•
Chapter 8, Configuring Alarms
, describes how to program alarm functions.
•
Chapter 9, Configuring Presets, Tours, Privacy Zones, and Sectors
, describes how to set
up presets, preset tours, mimic tours, privacy zone masks, and sectors (labels).
•
Chapter 10, Installing Dome Firmware
, describes how to install new firmware using the
firmware downloader tool.
•
Chapter 11, System Administration and Equipment Handling
, describes how to perform
various dome administrative functions.
•
Appendix A, ACUIX Specifications
, lists the specifications of the dome and provides
information about related products.
•
Appendix B, Troubleshooting
, provides a guide for resolving technical problems with
the dome.
•
Appendix C, Understanding Automatic Exposure and NightShot
, provides an overview of
exposure settings to assist with dome setup.
To Next Page
Loading...
