ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Document 800-05662V1 Rev A 61
04/11
Running a Preset Tour
These instructions apply only to domes configured for MAXPRO-mode, VCL,
VCL UTC, Pelco P, or Pelco D protocol.
You can select a preset tour to run by entering a special preset shortcut on your
controller.
To run a preset tour:
• Enter one of the following special presets on your controller:
• Preset 87 to run preset tour 1
• Preset 88 to run preset tour 2
• Preset 89 to run preset tour 3
• Preset 78 to run a preset tour other than 1, 2, or 3
If the dome is sent to an unprogrammed preset tour, the message
DOES NOT
EXIST
appears.
Stopping a Preset Tour
You can stop any preset tour by manually controlling the dome or by sending
the dome to a preset, a mimic tour, or another preset tour.
Viewing a List of Preset Tours
You can view the list of programmed preset tours on the screen.
To view the list of preset tours:
• Select 6 Function Programming
4 List PS/PT/Sectors 2 Preset
Tours.
To Next Page
Loading...
