Honeywell ACUIX - 5 Configuring PTZ Control; Setting PASS

Document 800-05662V1 Rev A 23
04/11
5
Configuring PTZ Control
This chapter contains the following sections:
• Setting PASS, page 23
• Setting Auto Pivot, page 24
• Setting the Pan and Tilt Speed, page 24
• Setting Pan Reverse, page 24
• Setting Tilt Reverse, page 25
• Setting the Tilt Limit, page 25
• Finding Home on Startup, page 25
• Setting the Pan Offset, page 26
• Setting the Startup State Restore, page 27
• Setting Auto Focus, page 27
• Setting Timed Auto Focus, page 28
Setting PASS
PASS adjusts the pan and tilt speed in proportion to the amount of zoom so that
the image on the monitor appears to be moving at the same speed when
zooming in and out. When PASS is enabled, the pan and tilt speed is slowed at
telephoto zoom settings, making it easier to position the camera.
To enable/disable PASS:
• Select 3 Control Options
 1 PASS  ON (default) or OFF.