Document 800-05662V1 Rev A 11
04/11
3
Preparing to Configure the Dome
This chapter contains the following sections:
•
Pre-Configuration Checklist
, page
11
•
Accessing the Main Menu
, page
12
•
Navigating OSD Menus
, page
13
•
Sending the Dome to a Preset
, page
13
•
Special Presets
, page
14
•
OSD Menu Tree
, page
15
Pre-Configuration Checklist
After you have installed the PTZ dome, you are ready to begin configuring the
dome settings from the OSD menu. To do this, you will need a keyboard
controller and a monitor.
The ACUIX High-Speed PTZ Dome is compatible with all Honeywell controllers,
including the UltraKey Touch, UltraKey Lite, UltraKey Plus, HJZTP, HKJMMTP,
and HEGS5300. It is also compatible with third-party controllers using Pelco P or
Pelco D control protocols.
Before you begin configuring the dome, do the following:
1. Make sure the dome is assigned to the controller you are using. The dome
address (for example, CAM 001) should appear on the controller LCD
display.
2. Turn on the dome.
3. Confirm that video is displaying on the monitor. A startup screen should
appear showing the protocol, baud rate, parity, data bits, camera type, and
firmware version of the dome.
4. If the dome does not "find home" automatically, enter a control command
(such as moving the joystick left or right). The message
Finding Home...
appears, followed by
Home Found.
To Next Page
Loading...
