ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Document 800-05662V1 Rev A 7
04/11
Setting the Baud Rate and Parity (SW6)
The baud rate and parity settings are determined by the protocol that you have
selected. Table 2-4 lists the baud rate and parity settings that correspond to each
protocol.
The baud rate and parity are set using DIP switch SW6 (see Table 2-5). The
factory default is 9600 baud, even parity.
Table 2-4 Baud Rate and Parity Settings by Protocol
Protocol Baud Rate and Parity
IntelliBus™ 38400 baud, no parity
MAXPRO-mode (default) 9600 baud, even parity
VCL - RS485 9600 baud, no parity
VCL UTC 9600 baud, no parity
Diamond 9600 baud, even parity
Pelco P 4800 baud, no parity
Pelco D 2400 baud, no parity
Pelco P_AD 4800 baud, no parity
Pelco D_AD 2400 baud, no parity
Table 2-5 SW6 Baud Rate and Parity Settings
Values Baud Rate Switch Position Parity Switch
Position
Other*
12345678
600 OFF OFF OFF OFF
1200
ON OFF OFF OFF
2400 OFF ON OFF OFF
4800 ON ON OFF OFF
9600 OFF OFF ON OFF
19200 ON OFF ON OFF
38400 OFF ON ON OFF
57600 ON ON ON OFF
115200 OFF OFF OFF ON
None OFF OFF OFF OFF
Even ON OFF OFF OFF
Odd OFF ON OFF OFF
* The default position for pins 7 and 8 is OFF (see Table 2-1).
To Next Page
Loading...
