ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Document 800-05662V1 Rev A 25
04/11
Setting Tilt Reverse
You can reverse the tilt so that a tilt up command from the controller will cause
the camera to tilt down and a tilt down command will cause the camera to tilt up.
To enable/disable tilt reverse:
• Select 3 Control Options
4 Set Pan and Tilt Options 3 Tilt Reverse
ON or OFF (default).
Setting the Tilt Limit
You can allow the camera to tilt five degrees above the horizontal using the −5
degree tilt limit feature.
To enable/disable −5 degree tilt limit:
• Select 3 Control Options
4 Set Pan and Tilt Options 4 −5 deg Tilt
Limit
ON or OFF (default).
Finding Home on Startup
By default, the dome automatically "finds home" on startup. You can disable this
setting if you want the dome to wait for a control input from the operator before
going to its "home" (index) position. To disable this setting, the Startup State
Restore must be set to OFF.
Note When a privacy zone is enabled, no video is displayed during the
finding home process. Privacy zones are not recognized until the
dome reaches home. After home is found, video is displayed on the
monitor unless a privacy zone overlaps with this home setting.
To Next Page
Loading...
