ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Document 800-05662V1 Rev A 33
04/11
To set the NightShot mode (manual or automatic):
1. Ensure that auto exposure is on (preset 92).
2. Select 5 Camera Options
3 NightShot Control 1 NightShot Mode
MAN (default) or AUTO.
To enable/disable NightShot:
1. Set NightShot mode to manual.
2. Select 5 Camera Options
3 NightShot Control 2 NightShot ON
or OFF (default).
Note Wide dynamic range mode is disabled when the camera enters
NightShot mode. It cannot be enabled while NightShot is on.
To set the NightShot activate point:
1. Set the NightShot mode to automatic.
2. Select 5 Camera Options
3 NightShot Control 3 Activate.
3. Select the desired activate setting by moving the controller joystick up or
down to navigate through the available video gain and shutter speed
values.
Video Gain Settings
• 0 dB, 2 dB, 4 dB, 6 dB, 8 dB, 10 dB, 12 dB, 14 dB, 16 dB, 18 dB,
20 dB (default), 22 dB, 24 dB, 26 dB, or 28 dB
Shutter Speed Settings
• NTSC = 1/4 s, 1/8 s, 1/15 s, 1/30 s, or 1/60 s (default)
• PAL = 1/3 s, 1/6 s, 1/12 s, 1/25 s, or 1/50 s (default)
To Next Page
Loading...
