58
Configuring Presets, Tours, Privacy Zones, and Sectors
7. If yes is selected, do one of the following:
• Press Focus Near to go to PTZ mode.
• Press Focus Far to go to the OSD menu.
Programming an Advanced Preset
After you have defined an advanced preset and configured PTZ settings (if
required), you can program the parameters of the preset. By default, all of the
parameters are set to NA (not applicable). When a parameter is set to NA, the
global OSD menu setting is used.
Note The list of advanced preset parameters is camera model dependent.
To program the parameters of an advanced preset:
• From the Advanced Preset Parameters menu, select the parameters you
want to program and set them to ON or OFF or Enable or Disable, or enter
a numerical value.
Defining Preset 79 as the User Default Setting Preset
You can define special preset 79 as the user default setting preset by creating
an advanced preset with default global settings. You can change these settings
by using preset 97 (see Defining an Advanced Preset above).
Preset 79:
• will be an advanced preset with default global settings that cannot be
deleted or changed to local settings.
• will not have any PTZ coordinates associated with it.
• can be restored only by clearing the memory or restoring the factory default
settings. The restore default setting has no effect on it.
Viewing a List of Advanced Presets
See Viewing a List of Presets on page 56.
Deleting an Advanced Preset
See Deleting a Preset on page 56.
To Next Page
Loading...
