ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Document 800-05662V1 Rev A 77
04/11
4. On your desktop, click Start, click Control Panel, and then double-click
Network Connections.
5. Double-click the connection you want to configure, and then click
Properties. The Local Area Connection Properties dialog box appears.
6. On the General tab, under This connection uses the following items,
click Internet Protocol (TCP/IP), and then click Properties. The Internet
Protocol (TCP/IP) Properties dialog box appears.
7. Click Use the following IP address, and in IP address, type
‘199.63.24.62’. Press the TAB key to populate Subnet mask automatically
(‘255.255.255.0’), and then click OK.
8. Turn on power to the dome, and then click Next.
The following message appears:
Download the New Firmware
If the connection is successful, the following screen appears:
1. Click the button to navigate to the ACUIX firmware combo file (*.acu)
saved on your computer. The Dome Application and FPGA Bit File boxes
should display the new version numbers under New Version.
2. Select the check boxes under Update, and then click Next to update the
firmware.
To Next Page
Loading...
