ACUIX High Speed Dome User Manual
Document 800-01023 Rev A 105
02/08
Restore Default Settings
Select 6 to restore all default settings for
displays, alarms, camera settings, and
diagnostic settings to the factory default
values. Select Y to restore all defaults or N to
cancel and return to the Diagnostic Options
menu.
Scan and Dome Reset
Select 7 to reset the scan and dome. This resets the ACUIX the same as if power had been
removed and then restored.
This can also be used to cause the ACUIX to find home.
Camera Options, 18X WDR & True Day/Night and 26X WDR, True/Day
Night Camera (FCB-EX490D and FCB-EX990D Respectively)
Note The information in this section applies to both the 18X and 26X cameras,
unless otherwise specified.
Select 5 from the Main menu to access the
Camera Options menu.
Caution This menu is for qualified technical personnel only. Changing the
Camera Options can make the video unusable. Restore the default
settings to bring video back.
****CAUTION****
This will restore all user
defined settings to their
default values. Are you sure
that you want to do this?
-Y/N-
CAMERA OPTIONS
1 Zoom and Focus
2 Exposure Control
3 NightShot Control
4 White Balance
5 Still Preset .......... OFF
6 Vert Phase Edge .. DISABLED
7 Vert Phase 0-359.9 .... 0.0
ESC to Exit
To Next Page
Loading...
