76
Operation and Programming with IntelliBus™ Protocol
Configuration Upload/Download
When ACUIX is set to IntelliBus protocol (see IntelliBus™, page 25), the ACUIX
configuration save feature can be used for replacement of faulty domes. The
configuration can be saved on a PC and later uploaded to a replacement dome in case
the original dome fails. However, the ACUIX configuration has camera specific
parameters so the configuration uploads (retrieving data from a faulty dome) and
downloads (sending data to a new dome) should be done only between two ACUIX units
that have the same camera model.
Caution Do not upload an ACUIX configuration file from one model of dome
camera to another. For example, the configuration from an ACUIX
dome camera with an FCB EX48C camera assembly should not be
uploaded to an ACUIX dome camera with a VK-S654 camera
assembly.
For detailed information on how to upload and download configuration files to an ACUIX,
please refer to the Rapid Eye™ System Administrator’s Guide.
Configuration Default
Whenever a camera is changed, the configuration is defaulted. To retain user settings,
save the configuration to a PC and then upload the saved configuration to the ACUIX
dome.
Configuration Data Saving
After completing the user programming of the ACUIX unit (presets, mimic tours, preset
tours, and on-screen setup menus), you can upload the configuration data to a PC for
safekeeping.
For detailed information on how to upload a configuration file to a PC, please refer to the
Rapid Eye™ System Administrator’s Guide.
To Next Page
Loading...
