54
Operation and Programming with Honeywell Diamond Protocol
6. Press + or - until P displays on the controller LCD and press Character Select.
7. Enter the new password, as done in step 5.
8. Re-enter the new password for verification. If you enter a different password the
second time, an Invalid message displays and you must start again.
9. After programming the password, you can program a Privacy Zone or press
Clear/Manual twice to exit programming.
Note If the password has been forgotten, the ACUIX can be reset to the default
password through the on-screen setup menus. See Resetting Privacy Zone
Password (Diamond or IntelliBus Protocols), page 81, in Chapter 6, ACUIX
Password Feature.
HJTZP Controller
For detailed information on the HJZTP controller see the HJZTP-US/HJZTP-EU User
Manual (900.0570).
Power Up
The operation of the ACUIX upon power up is the same as described on page 29.
Reset ACUIX
Press and hold Fn, then press F6 (menu), to send the return to manual (ESC) command.
This command cancels automatic dome actions such as preset tours and alarm actions.
Manual Control
Manual control of the ACUIX when using VCL protocol with the HJZTP controller is the
same as described in Chapter 3, Operation and Programming with Honeywell Diamond
Protocol.
To Next Page
Loading...
