ACUIX High Speed Dome User Manual
Document 800-01023 Rev A 61
02/08
4
Operation and Programming with Honeywell
VCL Protocol
Introduction
This chapter provides specific operation and programming information when the ACUIX
is set to Honeywell VCL protocol. Honeywell recommends using the HJZTP joystick
controller when using this protocol. Operation is the same as described in Chapter 3,
Operation and Programming with Honeywell Diamond Protocol with the exceptions noted
in the following paragraphs. Many of the features and programming options are accessed
by using pre-programmed Preset commands.
Note Although the information in this chapter is specific to the Honeywell VCL
protocol, when the ACUIX is set to MAXPRO, Pelco P or Pelco D protocol, the
ACUIX operates in a similar manner.
Power Up
The operation of the ACUIX upon power up is the same as described in Chapter 3,
Operation and Programming with Honeywell Diamond Protocol.
To Next Page
Loading...
