124
On-Screen Setup Menus
Gain PWM Level 0–100
If the Video Gain (UTP) is turned ON, the Gain PWM (Pulse Width Modulation) Level can be
set. The Gain setting amplifies the video to compensate for the resistance of the cable.
1. Select 3 from the Video Gain/PWM Setting Menu to change the current setting.
2. Enter the desired setting, between 0–100.
3. Press Enter.
Char White Level 0–100
The Char White PWM (Pulse Width Modulation) Level is used to brighten or darken the
characters in the on-screen displays. The default setting is 50.
1. Select 4 from the Video Gain/PWM Settings Menu to change the current setting.
2. Enter a value from 0 (dark) to 100 (bright).
3. Press Enter.
Caution Bright values can burn the phosphor in some monitors. The character
images may remain on the monitor due to the burning of the
phosphor.
Display Temperature
Select 2 from the Enhanced Features menu to turn the Temperature Display ON or OFF
(default). This feature displays the temperature of the ACUIX. If the Temperature Display is
turned on, it appears in the lower left corner of the video.
Temperature Format
Select 3 from the Enhanced Features menu to toggle between temperature formats:
FAHRENHEIT (default) and CELCIUS.
Table 7-19 Recommended Gain Settings for Cable Lengths
Cable Length Gain Setting
1200+ ft (365+ m) 55
900 ft (275 m) 42
600 ft (183 m) 35
300 ft (91 m) 25
To Next Page
Loading...
