84
On-Screen Setup Menus
Honeywell Diamond Protocol
HEGS5000/HEGS5001 Controller
When using the ACUIX dome in Honeywell Standard mode, the HEGS5000 or HEGS5001
controller is recommended. To access the on-screen setup menus using the HEGS5000
or HEGS5001 controller, perform the following procedure:
1. To access the ACUIX setup menus from the HEGS5000/HEGS5001, you must be
logged in as a Master user on the controller.
2. Press Dome Menu.
3. Press Enter to access the Dome Setup menu. The on-screen menu displays on the
monitor where the ACUIX video is viewed.
Note If password protection is enabled on the ACUIX, you must log into the ACUIX
with a supervisory password.
4. To access a submenu, press the number beside the menu option. The numbers
either toggle between the available choices or call up another menu.
5. If character entry is required in a field, press + or - until the desired character
displays on the LCD screen, and then press Character Select. The controller sends
the character to the ACUIX.
6. Press Clear/Manual to exit any ACUIX menu. Once you are out of the on-screen
setup menus on the monitor, press Menu ESC to exit the menus on the LCD display
and return to controlling the camera.
Note The HEGS5000/HEGS5001 controller does not support reverse polarity.
HJZTP Joystick Controller
The HJZTP controller can also be used with the Diamond protocol. Perform the following
procedure to access the ACUIX on-screen setup menus:
1. A user must be logged in as User Level 1 on the controller to access the ACUIX
on-screen menus.
2. Access the ACUIX dome menu by pressing and holding Lock, followed by F6
(Menu).
3. With SETUP flashing on the LCD screen, press Aux.
To Next Page
Loading...
