Honeywell ACUIX - Table 3-6 Preset Title Operation

ACUIX High Speed Dome User Manual
Document 800-01023 Rev A 41
02/08
Recall Presets
To recall a Preset:
1. Using the numeric keypad, enter the Preset number to recall (see Table 3-4 for
reserved Presets).
Note The HEGS5000 is limited to recalling Presets 0–99.
2. Press PreShot.
Example: Recall Preset 11.
1. Press 1.
2. Press 1 again.
3. Press PreShot.
Note If the ACUIX has not already found its home position, it will first find its home
position and then go to the preset.
The ACUIX goes to the pan, tilt, zoom, iris, and focus
positions programmed in the Preset. While the ACUIX is
going to a Preset position, the title of the Preset is added
to the video signal and the letter A (automatic) is added
to the camera ID. The Preset title and the letter A remain
on the video until the ACUIX gets another command.
CAM-0001 A
Table 3-6 Preset Title Operation
If: Then:
Preset title is on The Preset title displays on the monitor.
Camera message is on The Camera ID and the letter A are
displayed on the monitor.
An operator sends the ACUIX to a Preset
that has not been programmed
The message DOES NOT EXIST displays
on the monitor.