Honeywell ACUIX - Page 40

40
Operation and Programming with Honeywell Diamond Protocol
7. Program another Preset by repeating step 6 or press Clear/Manual to exit the Preset
programming menu.
8. Press Dome Menu or press Menu ESC three times to exit the menu on the controller
LCD.
Example: Program Preset 1, titled Front Door in Camera 1.
1. Select Camera 1.
a. Press 1.
b. Press Camera.
2. Position camera 1 to the desired Preset position (pan, tilt, zoom, focus, iris).
3. Press Dome Menu.
4. Press + or - until PreShot Menu displays on the LCD and press Enter.
5. Press + or - until Program displays on the LCD and press Enter.
6. Press 1 and press Enter.
7. Program the title.
a. Press + or - until an upper case F displays on the controller LCD and then press
Character Select.
b. Press + or - until a lower case r displays and then press Character Select.
c. Press + or - until a lower case o displays and then press Character Select.
d. Press + or - until a lower case n displays and then press Character Select.
e. Press + or - until a lower case t displays and then press Character Select.
f. Press + or - until Space displays and then press
Character Select.
g. Press + or - until an upper case D displays and then press Character Select.
h. Press + or - until a lower case o displays and then press Character Select.
i. Press + or - until a lower case o displays and then press Character Select.
j. Press + or - until a lower case r displays and then press Character Select.
k. Press Character Select.
8. Press + or - until an upper or lower case S displays on the controller LCD and then
press Character Select.
9. Program another Preset or press Clear/Manual to exit.
10. Press Dome Menu or press Menu ESC three times to exit the menus on the controller
LCD display.
S to Save Preset Press + or - until S displays on the LCD and press Character
Select. The current PTZ and lens (focus and iris) settings are
saved for the Preset number entered in step 6.
N to Save name only Press + or - until N displays on the LCD and press Character
Select. This option is used for retitling Presets. Only the title
entered in step 6b is saved for the Preset number entered. The
current PTZ and iris settings of the dome are not saved.
Table 3-5 Program Preset Menu Commands
Action Required Steps