24
Switch Settings
Parity
DIP Switch SW6, positions 5 and 6 are used to set the parity.
Note SW6, position 7 should be kept OFF. This switch is only used during
development for debugging purposes.
Sample Switch Settings
Legend for the following samples:
1 = On/ 0 = Off
Honeywell Diamond
For Honeywell Diamond protocol, the commonly used setting is 9600 baud, even parity.
SW5 - 10000001 (positions 1–8).
In above SW5–8 is ON to force reading from DIP switches. See DIP Switch Address
Override, page 26, for more information on setting SW5–8.
SW6 - 00101000 (positions 1–8) sets the ACUIX to 9600 baud with even parity.
Table 2-3 DIP Switch SW6 ACUIX Parity Settings
Parity
Switch Position
56
None OFF OFF
Even ON OFF
Odd OFF ON
To Next Page
Loading...
