62
Operation and Programming with Honeywell VCL Protocol
Reset ACUIX
The ACUIX can be reset through the setup menu or by a Preset command.
To reset the ACUIX through the setup menu:
1. Send the ACUIX to Preset 90 to access the setup menus.
2. Push the joystick down until 4 Diagnostics Menu is highlighted, then press Iris
Open.
3. Push the joystick down until the 7 Scan and Camera Reset option is
highlighted and then press Iris Open.
Note If the Autofocus is OFF when the setup menus are accessed — by sending
the ACUIX to Preset 90 — the Autofocus is automatically enabled.
Manual Control
Manual control of the ACUIX when using VCL protocol with the HJZTP controller is the
same as described in Chapter 3, Operation and Programming with Honeywell Diamond
Protocol.
Table 4-1 HJZTP Joystick Operation
Control Function
Joystick up
Joystick down
Joystick left
Joystick right
Tilt up
Tilt down
Pan left
Pan right
The speed of pan and tilt is relative to the amount of
movement applied to the joystick.
Joystick Knob Rotate the joystick knob clockwise and counterclockwise
to perform the zoom in and out functions, respectively.
The manual speed of the zoom function is set through the
on-screen setup menus under Camera Options.
To Next Page
Loading...
