Honeywell ACUIX - Baud Rate; Table 2-2 DIP Switch SW6 ACUIX Baud Rate Settings

ACUIX High Speed Dome User Manual
Document 800-01023 Rev A 23
02/08
Baud Rate
DIP SW6, position 1 through 4 are used to set the baud rate. The baud rate of the ACUIX
and the control equipment must be the same.
Note If there are invalid settings on SW5 or SW6 regarding protocol or baud rate,
the system defaults to Diamond protocol at 9600 baud rate.
Table 2-2 DIP Switch SW6 ACUIX Baud Rate Settings
Baud Rate
Switch Position
1234
600 OFFOFFOFFOFF
1200 ON OFF OFF OFF
2400 OFF ON OFF OFF
4800 ON ON OFF OFF
9600 OFF OFF ON OFF
19200 ON OFF ON OFF
38400 OFF ON ON OFF
57600 ON ON ON OFF
115200 OFF OFF OFF ON