58
Operation and Programming with Honeywell Diamond Protocol
Recall Preset
For example, to seek Preset 1:
1. Press key 1.
2. Press Preset. The camera moves at the maximum speed to the previously defined
Preset 1.
Presets 1 to 4 can also be selected by a single key press using the keys labelled Preset
1 to 4.
If a recall of an undefined preset number is attempted, the dome will not move and the
message ‘Does Not Exist’ displays on the screen.
Preset Tours
Preset tours function the same when using the HJZTP controller as described by Preset
Tours, page 43, however, the on-screen menus may be accessed differently when using
the HJZTP controller.
Note See Program a Preset Tour (Honeywell VCL and Supported 3rd Party
Protocols), page 117, in Chapter 7, On-Screen Setup Menus for more
information on setting up Mimic Tours. For more information on using the
HJZTP controller with the ACUIX on-screen menu, see HJZTP Joystick
Controller, page 84 and the HJZTP/HJZTP User Manual (900.0570).
Mimic Tours
Mimic tours function the same when using the HJZTP controller as described by Mimic
Tours, page 47, however, the on-screen menus may be accessed differently when using
the HJZTP controller.
Note See Mimic Tour (Honeywell Diamond Protocol Only), page 116, in Chapter 7,
On-Screen Setup Menus for more information on setting up Mimic Tours. For
more information on using the HJZTP controller with the ACUIX on-screen
menu, see HJZTP Joystick Controller, page 84 and the HJZTP/HJZTP User
Manual (900.0570).
To Next Page
Loading...
