Honeywell ACUIX - Table 7-3 Alarm Input Configuration; Table 7-4 Pan and Tilt Reverse Operation

96
On-Screen Setup Menus
Once the alarm condition is set for each alarm input, press ESC to exit the menu.
Set Pan and Tilt Options
Select 4 from the Control Options menu to
set the pan and tilt manual control options.
Manual Speed Deg/s
Select 1 from the Pan and Tilt Options menu
to change the manual pan and tilt speeds.
The maximum tilt speed is half of the
maximum pan speed. Select 1 to toggle
through the available options: 120°/sec, 240°/sec, or 480°/sec (default).
Pan Reverse
Select 2 to toggle Pan Reverse ON or OFF (default). See Table 7-4 for more information.
Tilt Reverse
Select 3 to toggle Tilt Reverse ON or OFF (default). See Table 7-4 for more information.
–5 Degree Tilt Limit
Select 4 to toggle the –5 Degree Tilt Limit ON or OFF (default). If set to on, an operator can
position the ACUIX tilt 5 degrees above horizontal.
Table 7-3 Alarm Input Configuration
If: Then:
The alarm condition is set to Open When the contact opens, an alarm occurs.
The alarm condition is set to Close When the contact closes, an alarm occurs.
PAN AND TILT OPTIONS
1 Manual Speed deg/s .. 480
2 Pan Reverse ......... OFF
3 Tilt Reverse ........ OFF
4 -5 Deg Tilt Limit ... OFF
5 Find Home on Startup OFF
6 Pan Offset
7 Startup State Restore OFF
ESC to Exit
Table 7-4 Pan and Tilt Reverse Operation
If: Then:
Pan Reverse is set to on A left pan command causes the ACUIX to pan
right. A right pan command causes the ACUIX to
pan left.
Tilt Reverse is set to on A tilt up command causes the ACUIX to tilt down.
A tilt down command causes the ACUIX to tilt up.