Honeywell ACUIX - Table 7-11 High Light White Balance Mode Settings

108
On-Screen Setup Menus
White Balance
Select 4 from the Camera Options menu
to set the White Balance Control options.
The default settings are shown to the
right.
High Light WB Mode
Select 1 to toggle between the available
settings for the High Light level white
balance mode. The available settings are AUTO (default), ATW, Indoor, and Outdoor.
Low Light WB Mode
Select 2 to toggle between the available settings for the Low Light level white balance
mode. The available settings are AUTO (default), ATW, Indoor, and Outdoor (see
Table 7-11 for an explanation of values).
Enter High Light
Select 3 to toggle between the available gain settings (0–28dB) and shutter speeds to set
the point where the unit switches to High Light level white balance mode.
Shutter Speed Settings:
PAL cameras = 1/3 sec, 1/6 sec, 1/12 sec, 1/25 sec, or 1/50 sec
NTSC cameras = 1/4 sec, 1/8 sec, 1/15 sec, 1/30 sec, or 1/60 sec
The High Light level mode cannot be set lower than the Low Light level mode.
Enter Low Light
Select 4 to toggle between the available gain settings (0–28dB) and shutter speeds to set
the point where the unit switches to Low Light level white balance mode.
Shutter Speed Settings:
PAL cameras = 1/3 sec, 1/6 sec, 1/12 sec, 1/25 sec, or 1/50 sec
WHITE BALANCE CONTROL
1 High Light WB Mode ....AUTO
2 Low Light WB Mode .....AUTO
3 Enter High Light 28dB 1/60s
4 Enter Low Light .28dB 1/30s
5 Manual White Balance ...OFF
6 NA
7 NA
ESC to Exit
Table 7-11 High Light White Balance Mode Settings
Setting Description
Auto Auto Tracing White Balance with limitations on R
and B gain (3,200°K to 6,000°K). Use this setting to
avoid fixing single color scenes as white.
ATW Auto Tracing White Balance (2,000°K to 10,000K°).
The camera tries to turn the dominant color within
the temperature color range to white.
Indoor The indoor mode sets the white balance to 3200°K.
Outdoor The outdoor mode sets the white balance to 5800°K.