ACUIX High Speed Dome User Manual
Document 800-01023 Rev A 69
02/08
Sector IDs
Sector IDs function the same for VCL protocol as described in Sector IDs, page 49, in
Chapter 3, Operation and Programming with Honeywell Diamond Protocol.
When using VCL protocol Sector IDs must be programmed using the on-screen setup
menu.
1. Press and hold ‘Lock’, then press ‘F6’ (‘Menu’) and then press ‘aux’ to enter the
ACUIX dome menu.
2. Use the tilt down function on the joystick until 6 Function Programming is
highlighted, and then press Iris Open.
3. Use the tilt down function on the joystick until 5 Program Sector is highlighted,
and then press Iris Open.
4. Use the tilt up function on the joystick until the desired Sector ID number (1–16)
displays, and then press Iris Open. Use the pan left and pan right functions to move
between digits, if necessary.
5. Press Focus Near to go to PTZ mode.
6. Position the video to the lower left corner of the Sector.
7. Press Focus Far to return to the programming menu.
8. Press Iris Open.
9. Press Focus Near to go to PTZ mode.
10. Position the video to the upper right corner of the Sector.
11. Press Focus Far to return to the programming menu.
12. Press Iris Open.
13. Program another Sector ID or press Iris Close to exit programming.
Privacy Zones
Privacy Zones function the same for VCL protocol as described in Privacy Zones, page
51, in Chapter 3, Operation and Programming with Honeywell Diamond Protocol.
To Next Page
Loading...
