114
On-Screen Setup Menus
Note You can change the Red and Blue Gain settings when the Manual White
Balance is set to OFF, but the settings do not take affect until the Manual
White Balance is set to ON.
When you are finished setting up the White Balance, press ESC. The display returns to
the Camera Options menu.
Still Preset
Select 5 from the Camera Options menu to turn Still Preset ON or OFF (default).
Vertical Phase 0–359.9
1. Select 6 from the Camera Options menu to enable or disable the Vertical Phase
Edge for line locking the camera. Selecting 6 toggles between DISABLED (default)
and ENABLED. If you enable the Vertical Phase Edge, you can set the Vertical
Phase from 0 to 359.9.
2. If enabled, select 7 to change the Vertical Phase.
3. Enter a number from 0 to 359.9 and press Enter.
When you are finished setting up the camera and lens, press ESC to exit the Camera
Options menu. The screen returns to the Main Setup menu. Select another menu option
or press ESC to exit the setup mode.
Table 7-16 Still Preset Operation
If: Then:
Still Preset is on
(video is frozen)
Video is frozen between Presets. The video remains at the
current Preset until the scan arrives at the next Preset, and
then switches the video. An asterisk displays to the left of the
camera ID when the ACUIX is moving between Presets. If an
operator manually controls the ACUIX, the Still Preset function
is disabled until the ACUIX is sent to another Preset.
Still Preset is off
(video is unfrozen)
Video returns to normal operation.
To Next Page
Loading...
