Honeywell ACUIX - Protocol and Baud Rate Settings

22
Switch Settings
Protocol Settings
DIP switch SW5 is used to select the protocol setting for your ACUIX. See Table 2-1 for
more information. The default protocol setting for the ACUIX is the Honeywell Diamond
protocol.
Note If there are invalid settings on SW5 or SW6 regarding protocol or baud rate,
the system defaults to Diamond protocol at 9600 baud rate.
Table 2-1 DIP Switch SW5 ACUIX Protocol Settings
Protocol Name
Switch Position
12345678
IntelliBus™ OFF OFF OFF OFF OFF OFF OFF OFF
Diamond ON OFF OFF OFF OFF OFF OFF OFF
MAXPRO Mode OFF ON OFF OFF OFF OFF OFF OFF
VCL - RS485 ON ON OFF OFF OFF OFF OFF OFF
VCL Video Telemetry
(Control over Coax)
OFF OFF ON OFF OFF OFF OFF OFF
Pelco P ON OFF ON OFF OFF OFF OFF OFF
Pelco D OFF ON ON OFF OFF OFF OFF OFF