Honeywell ACUIX - Page 145

ACUIX High Speed Dome User Manual
Document 800-01023 Rev A 145
02/08
passwords
enabling 79
for Privacy Zones 53
pelco emulation 139
Pelco settings. See protocol settings.
pendant, installing 20
PIN number, changing 80
power up
Diamond protocol 29
VCL protocol 61
preset names display option 90
presets
for Diamond protocol 38–46
for VCL protocol 64–68
menu commands 39
pre-programmed 38, 65
programming 38, 66
recalling 41, 66
still 42
still preset operation 42
title operations 41
tour commands 44
tours 43, 66
viewing programmed presets 42
presets, deleting 72
Privacy Zones 51, 69
and Home 51
commands 53
deleting 72
password 53
resetting password 81
program alarms control options 93
protocols
3rd party 87
Diamond 84
settings 22
VCL 85
VCL Coax control 86
R
Restore Default Settings diagnotic option 105
RJ-45 ethernet connector 27
RS485 settings. See protocol settings.
S
Scan and Dome Reset diagnotics option 105
sector ids 49, 69
commands 50
programming 49
sectors display option 90
sectors, deleting 72
setup menus 83–126
start-up screen message display option 90
still preset 42
Still Preset camera options
FCB-EX490 109
FCB-EX990 109
VK-S654 114
still preset operation 42
SW5 DIP switch 21
SW6 DIP switch 21
switches 21–27
DIP 21
location on main board 21
restoring factory defaults 27
rotary 21
sample settings 24
T
Temp Format Option 124
Time and Settings option 125
tour commands
preset 44
tours
mimic 47, 71
preset 43, 66
troubleshooting
cannot find home 130
jerky pan and tilt 130
lens out of optical focus 130
no control of video 129
no video 127
poor video reception 128
video is inverted 128
video zoom problem 131
U
unfreeze video 35, 63
V
VCL protocol 61–73
and HJZTP controller 85
power up 61
VCL settings. See protocol settings.
Vertical Phase camera options
FCB-EX490 110
FCB-EX990 110
VK-S654 114
video
freezing and unfreezing 35, 63
Video Gain/PWM Settings option 123
Video Setup camera options
VK-S654 112