Honeywell ACUIX - Page 48

48
Operation and Programming with Honeywell Diamond Protocol
Method 1 (Tours 1–3)
1. Press Dome Menu.
2. Press + or - until Tour Menu displays on the LCD and press Enter.
3. Press + or - until Run displays on the LCD and press Enter.
4. Enter the desired Tour number (1–3) using the numeric keys and press Enter. The
programmed Tour begins and runs continuously until the ACUIX receives another
command.
Method 2 (Tours 1–3)
1. Press Run Menu until Run Tour displays on the LCD and then press Enter.
2. Enter the desired Tour number (1–3) using the numeric keys and press Enter. The
programmed Tour begins and runs continuously until the ACUIX receives another
command.
Method 3 (Tours 1–16)
See Mimic Tour (Honeywell Diamond Protocol Only), page 116, in Chapter 7, On-Screen
Setup Menus, for more information on running Mimic Tours.
Delete a Mimic Tour
Perform one of the following methods to delete a Mimic Tour. Existing programming in a
Mimic Tour can also be overwritten by simply re-programming the Mimic Tour.
Method 1 (Tours 1–3)
1. Press Dome Menu.
2. Press + or - until Tour Menu displays on the LCD.
3. Press Enter.
4. Press + or - until Delete displays on the LCD.
5. Press Enter.
6. Enter the desired Tour number (1–3) using the numeric keys.
7. Press Enter.
Method 2 (Tours 1–16)
See Mimic Tour (Honeywell Diamond Protocol Only), page 116, in Chapter 7, On-Screen
Setup Menus, for more information on deleting a Mimic Tour.