To Next Page

To Previous Page

Contents

............................................................................................................................................................................................. 1

Section 1: Introduction ..................................................................................................................................................... 1

1.1: Overview of Basic System.................................................................................................................................................................................1

1.1.1: Hardware Features ..................................................................................................................................................................................1

1.1.2: Network System Hardware Features ......................................................................................................................................................1

1.1.3: Software Features ...................................................................................................................................................................................1

1.1.4: IFP-300ECS Features .............................................................................................................................................................................1

1.1.5: Terms Used in this Manual.....................................................................................................................................................................2

1.2: Compatible Products..........................................................................................................................................................................................2

Section 2: Agency Listings, Approvals, and Requirements......................................................................................... 5

2.1: Federal Communications Commission (FCC)...................................................................................................................................................5

2.2: Underwriters Laboratories (UL) ........................................................................................................................................................................5

2.2.1: Requirements for All Installations..........................................................................................................................................................5

2.2.2: Requirements for Central Station Fire Alarm Systems ..........................................................................................................................6

2.2.3: Requirements for Local Protected Fire Alarm Systems .........................................................................................................................6

2.2.4: Requirements for Remote Station Protected Fire Alarm Systems..........................................................................................................6

2.2.5: Requirements for the Installation of Carbon Monoxide (CO) Detection and Warning Equipment, NFPA 720....................................6

2.2.6: NFPA Requirements ...............................................................................................................................................................................6

Section 3: Before You Begin Installing .......................................................................................................................... 9

3.1: Inventory............................................................................................................................................................................................................9

3.2: Environmental Specifications ............................................................................................................................................................................9

3.3: Software Downloads..........................................................................................................................................................................................9

3.4: Electrical Specifications ....................................................................................................................................................................................9

3.5: Wiring Specifications.......................................................................................................................................................................................10

3.6: Board Assembly Diagram ...........................................................................................................................................................................12

3.7: Calculating Current Draw and Standby Battery ..............................................................................................................................................12

3.7.1: Current Draw Worksheet Requirements...............................................................................................................................................12

3.7.2: Current Draw Worksheet for IDP SLC Devices...................................................................................................................................13

3.7.3: Current Draw Worksheet for SK SLC Devices....................................................................................................................................16

3.7.4: Current Draw Worksheet SD for SLC Devices....................................................................................................................................20

3.7.5: Maximum Battery Standby Load..........................................................................................................................................................22

Section 4: Control Panel Installation ............................................................................................................................. 25

4.1: Mounting the Control Panel Cabinet ...............................................................................................................................................................25

4.1.1: Preventing Water Damage ....................................................................................................................................................................25

4.1.2: Removing the IFP-300/ECS Assembly from the Housing...................................................................................................................25

4.1.3: Ethernet Connection .............................................................................................................................................................................25

4.2: AC Connection.................................................................................................................................................................................................25

4.3: Battery Power ..................................................................................................................................................................................................26

4.3.1: RBB Accessory Cabinet .......................................................................................................................................................................27

Installing the RBB Accessory Cabinet and Batteries .............................................................................................................................27

4.4: SBUS Wiring ...................................................................................................................................................................................................28

4.4.1: Calculating Wiring distance for SBUS modules ..................................................................................................................................28

4.4.2: Wiring Configurations ..........................................................................................................................................................................30

4.5: RA-100 Remote Annunciator Installation .......................................................................................................................................................31

4.5.1: Mounting the RA-100...........................................................................................................................................................................31

Flush Mounting.......................................................................................................................................................................................31

Surface Mounting ...................................................................................................................................................................................33

4.5.2: Connecting the RA-100 to the Panel ......................................................................................

..............................................................34

4.6: RA-1000 Remote Annunciator Installation .....................................................................................................................................................35

4.6.1: Mounting the RA-1000.........................................................................................................................................................................35

Flush Mounting.......................................................................................................................................................................................36

4.6.2: Connecting the RA-1000 to the Panel ..................................................................................................................................................36

4.7: RA-2000 Remote Annunciator Installation .....................................................................................................................................................37

4.7.1: Mounting the RA-2000.........................................................................................................................................................................37

Flush Mounting.......................................................................................................................................................................................37

Surface Mounting ...................................................................................................................................................................................39