To Next Page

To Previous Page

8Ć4 Troubleshooting

C3187Ć90000

What You Should See and Hear

When you turn on the plotter, the following happens:

1 All six LEDs light up for a brief moment; then the

Busy LED remains on.

                

  

Busy

  

2 The stepper motor makes a buzzing noise.

3 The cartridge carriage knocks against the leftĆhand side.

4 The carriage moves across the plotter and knocks three times against the rightĆhand side.

5 The carriage returns to the leftĆhand side.

6 Any loaded sheet of media is ejected.

7 If either cartridge is not correctly positioned, the carriage moves to a position where you

can access it; the

Cartridges LED lights up indicating that you have to load, reseat or

replace the cartridges. (Instructions  User's Guide.)

8 The cartridges are cleaned in the service station on the leftĆhand side of the plotter.

During the cleaning process, the carriage moves slightly a number of times for the wiper

to wipe the nozzles.

9 The carriage then parks in the service station on the leftĆhand side of the plotter.

10 If you have loaded or reseated the cartridges, the

Cartridges and Load Media LEDs flash,

indicating that the first sheet of media that you load will be used to run the

cartridgeĆalignment procedure (Details  chapter 7.)

11 If the cartridges are already aligned, the

Load Media LED lights up to indicate that the

plotter is ready for you to load media.

HP 200 User Manual

Questions and Answers: