Condition Suggested solutions
The unit scans very slowly. ● Check if the printer is printing received data. If so, scan the
document after the received data has been printed.
● Graphics are scanned more slowly than text.
● Communication speed slows in scan mode because of the
large amount of memory required to analyze and reproduce
the scanned image. Set your computer to the ECP printer
mode through BIOS setting. It will help to increase the speed.
For details about how to set BIOS, refer to your computer
user’s guide.
Message appears on your computer screen:
● Device can’t be set to the H/W mode you want.
● Port is being used by another program.
● Port is Disabled.
● Scanner is busy receiving or printing data. When the current
job is completed, try again.
● Invalid handle.
● Scanning has failed.
● There may be a copying or printing job in progress. Try your
job again when that job is nished.
● The selected port is currently being used. Restart your
computer and try again.
● The printer cable may be improperly connected or the power
may be o.
● The scanner driver is not installed or the operating
environment is not set up properly.
● Ensure that the printer is properly connected and the power is
on, then restart your computer.
● The USB cable may be improperly connected or the power
may be o.
Additional troubleshooting tasks
Go to support.hp.com
Instructions are available for performing specic print tasks, such as the following:
● Fax troubleshooting (optional fax accessory required)
ENWW Solving other problems 155
To Next Page
Loading...