● Do not use envelopes with clasps, snaps, windows, coated lining, self-adhesive seals, or other synthetic
materials.
● Do not use damaged or poorly made envelopes.
● Be sure the seam at both ends of the envelope extends all the way to the corner of the envelope.
1 Acceptable
2 Unacceptable
● Envelopes with a peel-o adhesive strip or with more than one ap that folds over to seal must use
adhesives compatible with the printer’s fusing temperature of about 170°C (338 °F) for 0.1 second. The
extra aps and strips might cause wrinkling, creasing, or jams, and may even damage the fuser.
● For the best print quality, position margins no closer than 15 mm (0.6 inches) from the edges of the
envelope.
● Avoid printing over the area where the envelope’s seams meet.
Labels
Load the paper with the side to be printed on facing down.
To avoid damaging the printer, use only labels designed for use in laser printers.
ENWW Printing on special media 55
To Next Page
Loading...