Scanning and sending via SMB/FTP
If you install a mass storage device (hard disk), you can send scanned images to up to ten dierent destinations
via SMB or FTP. Without a mass storage device, you can only send scanned images to a single destination via
SMB or FTP.
NOTE: To scan and send an image to a server, you need to set up network parameters using the control panel
(see "Setting up an FTP/SMB server").
●
Understanding the Scan to Server screen
●
Setting up an FTP/SMB server
●
Scanning and sending to an SMB/FTP server
●
Resending to the last server address
Understanding the Scan to Server screen
Press Scan to Server in the display screen.
Basic tab
● File Name: Makes the le name for the le to be sent.
● File Format: Select the le format before you proceed with the scanning job.
● Recent: Shows the latest email addresses used. Also, you can choose email addresses instead of pressing
the pop-up keyboard (see "Resending to the last email address").
● Resolution: Selects scanning resolution value.
● Darkness: Adjusts the degree of darkness of scanned output.
● Address Book (Favorite ( ), All, ABC, 123/!@#): Inputs the recipient's address by pressing stored
addresses. You can save frequently used email addresses using the control panel (see "Setting up an
address book from the control panel").
● Programs: Allows you to save the current settings for future use (see "Using a programs setting").
Advanced tab
● Original Size: Selects the size of originals.
●
Original Orientation: Selects the orientation of the originals.
● Duplex: For originals that are scanned on both sides.
● Build Job: After the scanning is nished, the Scan More Pages window appears to ask if you want to scan
another page. If you select Yes, then you can scan another page in the current job. If you select No, then
the scanning process is completed and the remainder of the job is performed.
ENWW Scanning and sending via SMB/FTP 85
To Next Page
Loading...