EasyManua.ls Logo

HP LaserJet M72625dn Series

HP LaserJet M72625dn Series
173 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE:
The folder to save the scanned image must be on the root.
The folder properties need to be setup as a share.
Your user name should have the rights to read and write the folder.
13. Press Apply.
Scanning and sending to an SMB/FTP server
You can select destinations using SMB, or FTP servers.
NOTE: To scan and send an image to a server, you need to set up network parameters using the control panel
(see "Setting up an FTP/SMB server").
1. Place the originals face up in the document feeder or place a single original face down on the scanner glass
and close the document feeder (see "Loading originals").
2. Press Scan to Server from the display screen.
3. Set the scan features in the Advanced, Image, or Output tabs (see "Changing the scan feature settings").
4. Press the Basic tab.
5. Press the server name input area, you can enter a recipient’s server address manually. You cannot enter an
address in the second eld before entering an address in the rst eld.
You can also use Address Book to enter the addresses easily (see "Setting up an Address Book").
6. Set the scan quality by Duplex and Resolution.
7. Press (Start) on the control panel.
The printer begins scanning and then sends the scanned image to the specied server.
If an original is placed on the scanner glass, the printer shows the window asking if you want to place
another page. Load another original and press Yes. When you nish, press No on this window.
NOTE:
To cancel the current scan job, press (Stop) on the control panel. Or you can delete current and
pending jobs using Job Status on the control panel. Select the job you want to cancel and press
Delete (see "Job Status button").
While the printer is sending a scanned data, you cannot use the printer to copy or to send a fax.
Resending to the last server address
To resend a le to the server address last sent to:
1. Place the originals face up in the document feeder or place a single original face down on the scanner glass
and close the document feeder (see "Loading originals").
2. Press Scan to Server from the display screen.
ENWW Scanning and sending via SMB/FTP 87

Table of Contents

Related product manuals