Linux
You need to download Linux software packages from the HP Linux Imaging and Printing (HPLIP) website to
install the printer software.
1. Make sure that the printer is connected to your network and powered on. Also, your printer’s IP address
should have been set.
2. Copy Unied Linux Driver package to your system.
3. Open Terminal program and go to the folder that you copied the package to.
4. Extract the package.
5. Move to uld folder.
6. Execute ” ./install.sh“ command (If you are not logged in as root, execute the command with “sudo” as
“sudo ./install.sh”).
7. Proceed with installation.
8. When installation nished, launch Printing utility (Go to System > Administration > Printing or execute
“system-cong-printer“ command in Terminal program).
9. Click Add button.
10. Select AppSocket/HP JetDirect and enter your printer’s IP address.
11. Click Forward button and add it to your system.
ENWW Installing driver over the network 29
To Next Page
Loading...