Card stock/ Custom-sized paper
● Do not print on media smaller than 98 mm (3.8 inches) wide or 148 mm (5.8 inches) long.
● In the software application, set margins to at least 6.4 mm (0.25 inches) away from the edges of the
material.
Letterhead/Pre-printed paper
Table
3-10 Letterhead / Pre-printed paper
Tray Single-sided Double-sided
Standard tray/Optional dual
cassette feeder
Face up Face down
Tray 1 (MP) Face down Face up
● Preprinted paper must be printed with heat-resistant ink that will not melt, vaporize, or release hazardous
emissions when subjected to the printer’s fusing temperature of about 170°C (338 °F) for 0.1 second.
● Preprinted paper ink must be non-ammable and should not adversely aect printer rollers.
● Forms should be sealed in a moisture-proof wrapping to prevent changes during storage.
● Before you load preprinted paper, verify that the ink on the paper is dry. During the fusing process, wet ink
can come o preprinted paper, reducing print quality.
Additional information for printing on special media
Go to support.hp.com. Instructions are available for performing specic scan tasks, such as the following:
● Special media types and what each tray will support
ENWW Printing on special media 57
To Next Page
Loading...