Turning on the printer
CAUTION: To prevent damage to the printer, use only the power cord that is provided with the printer.
NOTE: Make sure that the power source is adequate for the printer voltage rating. The voltage rating is on the
printer label. The printer uses either 110-127 Vac or 220-240 Vac and 50/60 Hz. A label with the printer voltage
rating is located on the back of the printer.
1. Plug the power cord into the power receptacle.
2. Plug the other end into a properly grounded AC outlet.
ENWW Turning on the printer 15
To Next Page
Loading...