HP ProLiant ML370 Generation 4 - Page 184

184 HP ProLiant ML370 Generation 4 Server Reference and Troubleshooting Guide
Remote ROM flash problems
List of problems:
General remote ROM flash problems are occurring...................................................................184
Command-line syntax error........................................................................................................184
Invalid or incorrect command-line parameters...........................................................................185
Access denied on target computer..............................................................................................185
Network connection fails on remote communication.................................................................185
Failure occurs during ROM flash ...............................................................................................185
Target system is not supported ...................................................................................................185
•
•
•
•
•
•
•
General remote ROM flash problems are occurring
Action: Be sure you follow these requirements for using the Remote ROM flash
utility:
A local administrative client system that is running the Windows® 2000 or
Windows® Server 2003 operating system
One or more remote servers with system ROMs requiring upgrade
An administrative user account on each target system. The administrative
account must have the same username and password as the local
administrative client system.
All target systems are connected to the same network and use protocols that
enable them to be seen from the administrative client.
Each target system has a system partition that is at least 32 MB in size.
Verification that the ROM version to which you are upgrading can be used
for all the servers or array controllers that you are upgrading.
Follow the instructions for the Remote ROM Flash procedure that
accompany the software.
Command-line syntax error
If the correct command-line syntax is not used, an error message describing the
incorrect syntax is displayed and the program exits. Correct the syntax, and then
restart the process.