Troubleshooting 225
Wrong Accelerator
Description: This may mean that the board was replaced in the wrong slot or
was placed in a system previously configured with another board type. Included
with this message is a message indicating (1) the type of adapter sensed by ADU,
and (2) the type of adapter last configured in EISA NVRAM.
Action: Check the diagnosis screen for other error messages. Run the server
setup utility to update the system configuration.
POST error messages and beep codes
List of messages:
Introduction to POST error messages.........................................................................................225
Non-numeric messages or beeps only ........................................................................................226
100 Series ...................................................................................................................................236
200 Series ...................................................................................................................................240
300 Series ...................................................................................................................................246
400 Series ...................................................................................................................................247
600 Series ...................................................................................................................................248
1100 Series .................................................................................................................................250
1600 Series .................................................................................................................................251
1700 Series .................................................................................................................................257
Introduction to POST error messages
The error messages and codes in this section include all messages generated by
ProLiant servers. Some messages are informational only and do not indicate any
error. A server generates only the codes that are applicable to its configuration
and options.
HP ProLiant p-Class server blades do not have speakers and thus do not support
audio output. Disregard the audible beeps information if the server falls into this
category.
IMPORTANT: This guide provides information for multiple servers.
Some information may not apply to the server you are troubleshooting.
Refer to the server documentation for information on procedures,
hardware options, software tools, and operating systems supported by
the server.
To Next Page
Loading...
Need help?
General
