HP ProLiant ML370 Generation 4 - Expansion Boards

82 HP ProLiant ML370 Generation 4 Server Reference and Troubleshooting Guide
3. Connect the power cord to the redundant power supply.
4. Use the power cord management clip on the power supply to secure the cord
and form a service loop.
5. Connect the power cord to the power source.
6. Be sure that the power supply LED is green ("Rear panel LEDs and buttons"
on page 13
).
7. Be sure that the front panel external health LED is green ("Front panel LEDs
and buttons" on page 10
).
IMPORTANT: For maximum server availability, be sure that the two
power supplies are powered by separate AC power sources.
NOTE: If you remove or replace the primary hot-plug power supply, use
the T-15 Torx screwdriver provided with the server to remove the
shipping screw from the upper left corner of the power supply unit.
Expansion boards
The server supports PCI-X and PCI Express expansion boards.
Slot Expansion
card type
Connector Capable speed
1 PCI-X 64-bit, 3.3-volt 100-MHz
2 PCI-X 64-bit, 3.3-volt 100-MHz