HP ProLiant ML370 Generation 4 - 1713-Slot Z Drive Array Controller - Redundant ROM Reprogramming Failure

258 HP ProLiant ML370 Generation 4 Server Reference and Troubleshooting Guide
1754-Slot x Drive Array - RAID ADG configured but ADG is not supported on this controller
model. .........................................................................................................................................263
1762-Slot x Drive Array - Controller Firmware Upgrade Needed.............................................263
1763-Array Accelerator Daughtercard is Detached; Please Reattach ........................................263
1764-Slot X Drive Array - Capacity Expansion Process is Temporarily Disabled....................264
1768-Slot X Drive Array - Resuming Logical Drive Expansion Process ..................................264
1769-Slot X Drive Array - Drive(s) Disabled Due to Failure During Capacity Expansion.......264
1770-Slot X Drive Array - SCSI Drive Firmware Update Recommended - ... ..........................265
1774-Slot X Drive Array - Obsolete Data Found in Array Accelerator.....................................266
1775-Slot X Drive Array - ProLiant Storage System Not Responding SCSI Port Y:................266
1776-Slot X Drive Array - SCSI Bus Termination Error...........................................................266
1776-Drive Array Reports Improper SCSI Port 1 Cabling.........................................................267
1777-Slot X Drive Array - ProLiant Drive Storage Enclosure Problem Detected.....................268
1778-Drive Array Resuming Automatic Data Recovery Process ..............................................269
1779-Slot X Drive Array - Replacement drive(s) detected OR previously failed drive(s) now
operational:.................................................................................................................................269
1783-Slot X Drive Array Controller Failure ..............................................................................269
1783-Intelligent Drive Array Controller Failure ........................................................................270
1784-Slot X Drive Array Drive Failure. The Following SCSI Drive(s) Should Be Replaced:
SCSI Port Y: SCSI ID Z.............................................................................................................270
1785-Slot X Drive Array Not Configured..................................................................................270
1786-Slot 1 Drive Array Recovery Needed................................................................................271
1786-Slot 1 Drive Array Recovery Needed. Automatic Data Recovery Previously Aborted!...272
1787-Drive Array Operating in Interim Recovery Mode...........................................................272
1788-Slot X Drive Array Reports Incorrect Drive Replacement... ............................................273
1789-Slot X Drive Array SCSI Drive(s) Not Responding... ......................................................274
1792-Drive Array Reports Valid Data Found in Array Accelerator...........................................275
1793-Drive Array - Array Accelerator Battery Depleted - Data Lost. (Error message 1794 also
displays.).....................................................................................................................................275
1794-Drive Array - Array Accelerator Battery Charge Low......................................................275
1795-Drive Array - Array Accelerator Configuration Error... ...................................................276
1796-Drive Array - Array Accelerator Not Responding... .........................................................276
1797-Drive Array - Array Accelerator Read Error Occurred.....................................................276
1798-Drive Array - Array Accelerator Self-Test Error Occurred... ...........................................277
1799-Drive Array - Drive(s) Disabled Due to Array Accelerator Data Loss.............................277
1713-Slot z Drive Array Controller - Redundant ROM Reprogramming
Failure...
...Replace the controller if this error persists after restarting system.