Hardware options installation 67
9. Install SAS or SATA hard drives into the desired bays of the drive cage.
10. Determine the status of each drive by observing the drive LEDs ("SATA or
SAS hard drive LEDs" on page 24
).
CAUTION: To prevent improper cooling and thermal damage,
do not operate the server unless all bays are populated with either a
component or a blank.
The installation is complete.
Removable media devices
Accessing the Removable Media Cage (on page 68)
Half-Height or Full-Height Media Devices ("Installing a half-height or full-
height media device" on page 70
)
Internal Two-Bay Hot-Plug SCSI Drive Cage ("Installing an optional internal
two-bay hot-plug SCSI drive cage" on page 73
)
To Next Page
Loading...
