HP ProLiant ML370 Generation 4 - SAS-SATA Hard Drive Cage; Removing the Hard Drive Cage

62 HP ProLiant ML370 Generation 4 Server Reference and Troubleshooting Guide
2. Install the hard drive.
3. Determine the status of the hard drive from the hot-plug hard drive LEDs
("Hot-plug SCSI hard drive LED combinations" on page 23
, "Hot-plug SCSI
hard drive LEDs" on page 22
).
4. Resume normal server operations.
SAS-SATA hard drive cage
You can install an eight-bay, hot-plug SAS-SATA drive cage in the HP ProLiant
ML370 Generation 4 Server (tower and rack models). A combination of up to
eight SAS and SATA hard drives can be installed in the drive cage.
Removing the hard drive cage
Before you install the SAS-SATA hard drive cage, you must first remove the
hard drive cage already installed.
1. Power down the server ("Powering down the server" on page 27
).
2. Unlock and open the front bezel ("Unlocking the front tower bezel" on page
29
) (tower servers only).
3. Remove the rack bezel (rack servers only).