Troubleshooting 193
Accelerator Status: Cache was Automatically Configured During Last Controller Reset .........197
Accelerator Status: Data in the Cache was Lost.........................................................................197
Accelerator Status: Dirty Data Detected has Reached Limit......................................................197
Accelerator Status: Dirty Data Detected.....................................................................................197
Accelerator Status: Excessive ECC Errors Detected in at Least One Cache Line... ..................198
Accelerator Status: Excessive ECC Errors Detected in Multiple Cache Lines... .......................198
Accelerator Status: Obsolete Data Detected...............................................................................198
Accelerator Status: Obsolete Data was Discarded......................................................................199
Accelerator Status: Obsolete Data was Flushed (Written) to Drives..........................................199
Accelerator Status: Permanently Disabled .................................................................................199
Accelerator Status: Possible Data Loss in Cache .......................................................................199
Accelerator Status: Temporarily Disabled..................................................................................199
Accelerator Status: Unrecognized Status....................................................................................200
Accelerator Status: Valid Data Found at Reset ..........................................................................200
Accelerator Status: Warranty Alert ............................................................................................200
Adapter/NVRAM ID Mismatch .................................................................................................200
Array Accelerator Battery Pack X not Fully Charged................................................................200
Array Accelerator Battery Pack X Below Reference Voltage (Recharging)..............................201
Board in Use by Expand Operation............................................................................................201
Board not Attached.....................................................................................................................201
Cache Has Been Disabled Because ADG Enabler Dongle is Broken or Missing......................201
Cache Has Been Disabled; Likely Caused By a Loose Pin on One of the RAM Chips.............201
Configuration Signature is Zero .................................................................................................202
Configuration Signature Mismatch ............................................................................................202
Controller Communication Failure Occurred.............................................................................202
Controller Detected. NVRAM Configuration not Present..........................................................202
Controller Firmware Needs Upgrading ......................................................................................202
Controller is Located in Special "Video" Slot............................................................................203
Controller Is Not Configured......................................................................................................203
Controller Reported POST Error. Error Code: X .......................................................................203
Controller Restarted with a Signature of Zero............................................................................203
Disable Command Issued ...........................................................................................................204
Drive (Bay) X Firmware Needs Upgrading................................................................................204
Drive (Bay) X has Insufficient Capacity for its Configuration ..................................................204
Drive (Bay) X has Invalid M&P Stamp .....................................................................................204
Drive (Bay) X Has Loose Cable.................................................................................................204
Drive (Bay) X is a Replacement Drive.......................................................................................205
Drive (Bay) X is a Replacement Drive Marked OK...................................................................205
Drive (Bay) X is Failed ..............................................................................................................205
Drive (Bay) X is Undergoing Drive Recovery...........................................................................205
To Next Page
Loading...
