3. Tighten the retaining screw to secure the cover to the chassis.
Removing and Replacing the Front Bezel
Figure 6-6 Bezel hand slots
Removing the Front Bezel
• From the front of the server, grasp both sides of the bezel and pull firmly toward you. The
catches will release and the bezel will pull free.
Replacing the Front Bezel
• From the front of the server, grasp both sides of the bezel and push toward the server. The
catches will secure the bezel to the chassis.
Removing and Replacing PCA Front Panel Board
The front panel board is located in the front of the chassis. All system power must be removed
before attempting to remove or replace this component.
Removing and Replacing the Front Bezel 147
To Next Page
Loading...
