Refer to power cord policies to interpret LED indicators.
3. Log in to the MP:
a. Enter Admin at the login prompt. The login is case sensitive.
It takes a few moments for the MP prompt to display. If it does not, be sure the laptop
serial device settings are correct: 8 bits, no parity, 9600 baud, and na for both Receive
and Transmit. Then, try again.
b. Enter Admin at the password prompt. The password is case sensitive.
The MP Main Menu is displayed:
Figure 3-30 MP Main Menu
Configuring LAN Information for the MP
This section describes how to set and verify the server management processor (MP) LAN port
information. LAN information includes the MP network name, the MP IP address, the subnet
mask, and the gatway address. This information is provided by the customer.
To set the MP LAN IP address:
1. At the MP Main Menu prompt (MP>) enter cm to enter the MP Command.
NOTE: If the Command Menu is not shown, enter q to return to the MP Main Menu, then
enter cm..
2. From the MP Command Menu prompt (MP:CM>) enter lc (for LAN configuration).
The screen displays the default values and asks if you want to modify them. Write down
the information or log it in a file, as it may be required for future troubleshooting. See
.Figure 3-31
Cabling and Power Up 77
To Next Page
Loading...
Need help?
General