10. A screen similar to the following is displayed, allowing verification of the settings:
Figure 3-32 The ls Command Screen
11. To return to the MP main menu, enter ma.
12. To exit the MP, enter x at the MP main menu.
Accessing the Management Processor via a Web Browser
Web browser access is an embedded feature of the MP/SCSI card. The Web browser enables
access to the server through the LAN port on the core I/O card. MP configuration must be done
from an ASCII console connected to the Local RS232 port..
NOTE: The MP/SCSI card has a separate LAN port from the system LAN port. It requires a
separate LAN drop, IP address, and networking information from that of the port used by HP-UX.
Before starting this procedure, the following information is required:
• IP address for the MP LAN
• Subnet mask
• Gateway address
• Host name (this is used when messages are logged or printed)
To configure the LAN port for a Web browser, perform the following steps:
1. Connect to the MP using a serial connection.
2. Configure the MP LAN. Refer to “Configuring LAN Information for the MP”.
3. Type CMto enter the Command Menu.
4. Type SA at the MP:CM> prompt to display and set MP remote access.
Cabling and Power Up 79
To Next Page
Loading...
